Speaker Level Output: 1 x Rear Panel Mounted Neutrik NL4. ![]() Low Pass Filters: 4th Order Linkwitz Riley Electronic Specifications R1-300 (Remote Amp)īalanced Inputs: 2 x Front Panel Mounted Female XLR, pin 2 hot.īalanced Outputs: 2 x Front Panel Mounted Male XLR, pin 2 hot. Power/Clip & Mute LEDs Input: 1 x Rear Panel Mounted 5-Pin Female XLR. Speaker Level Input: 1 x Rear Panel Mounted Neutrik NL4. Sensitivity: +4dBu ref 88dBC (single input driven, Gain +6dB, Level 0dB, pink noise, low pass filter 80Hz). Full Power 500W/600VA.Īdditional: Mute via ¼”/ 6.35mm Jack socket, controlled via latching footswitch (supplied separately) Physical Specificationsĭimensions: (H x W x D): 568 x 464 x 500mm / 22 5/16 x 18 1/4 x 19 11/16 inches (heatsink protrudes a further 40mm / 1 9/16 inches from rear). Polarity Control: In-phase/Out-of-phase ref. Total range 21dB with use of Gain switch. THD+N: <0.003%/-90dB, at 100Hz, 300W into 8Ω over 90kHz bandwidth.īalanced Inputs: 2 x Rear Panel Mounted Female XLR, pin 2 hot.īalanced Outputs: 2 x Rear Panel Mounted Male XLR, pin 2 hot.įrequency Response: <2Hz (-3dB) – 320Hz (-6dB, set by panel-controlled LP filter). Electronic SpecificationsĪmplifier type: Grounded Source MOSFET based Class A-B, convection cooled. ![]() Sensitivity: +4dBu ref 88dBC (single input driven, 1m, Gain +6dB, Level 0dB, pink noise, low pass filter 80Hz). MaxSPL: 110dB continuous, 116dB peak (IEC Weighted Pink Noise, 1m, half space, low pass filter 80Hz). Low Frequency Cut-off: 22Hz (-6dB, half space, low pass 80Hz).
0 Comments
Leave a Reply. |